Application Instruction

1. Set HeatPress to 127°C and maximum Pressure. Use Temperature Test Strips to verify your Heat Press's actual Surface Temperature.

2. Print Mask as black&white negative mirrored on 100 gsm Colour Laser Paper to avoid shrinkage of the mask and mismatch of mSheet to iSheet.

3. Place WoWPad on Heat Press with smooth side up and pre-press when you start cold. Note: Good retained Temperature at the first Step is important for a good final result! Place mSheet coated side up on WoWPad and Mask on top. Cover with Release Paper and press for 10 seconds. Open press and strip Mask Paper off the mSheet immediately and in one smooth move without stopping.
Note: Do not remove Release Paper before you strip the Mask, it will retain the heat whilst peeling.

4. Remove mSheet and WoWPad off the HeatPress. Place Release Paper on Heat Press and iSheet printed side up on top. Place and align mSheet on top to match the Image(s) with the masked white Film areas. Cover with WoWPad smooth side up and press for 30 to 40 seconds (depending on the thickness of your WoWPad). Open Heat Press, remove WoWPad and take the m&iSheet stack of the Press. Wait until the stack is really cold and strip mSheet backing paper including the outer border of the white film off the iSheet.
Tip: Holding the stack against glass or metal surface cools it down faster!

5. Place Garment on the Heat Press and position iSheet with final transfer face down on top. Press for 5 seconds, for finer details and/or coarser weave up to 10 seconds. Open Heat Press and let Transfer go cold. Gently separate the backing paper from the iSheet.

Note: If you encounter any grey colour Coating Residue or white spots outside the image area you can remove it with regular office tape.

Finally, cover with Release Paper and press again for 15 seconds. Let cool down for a few seconds and remove Release Paper.